FUHONG focus on high-end injection machine technology for plastic moulding machine solution since 2006.

Injection molding machine oil cylinder the matters needing attention during installation

by:FUHONG     2020-10-02
1, in travel, environmental temperature higher, oil cylinder can only be fixed at one end, on the other side must be kept free expansion, to prevent thermal deformation caused by the cylinder. 2, pin hole of piston rod end should pin hole with earring ( Or trunnion) In the same direction, or servo energy-saving injection molding machine oil cylinder will the trunnion as fulcrum bending load, produce the phenomenon such as wear, jammed. 3, before the installation, it is necessary to carefully check the shaft end, hole, the place such as the processing quality, chamfering and remove burrs, then clean with kerosene or gasoline and blow dry. 4, the installation surface and sliding surface of piston, should maintain a certain degree of parallelism and perpendicularity. 5, the center line of the oil cylinder should be concentric with the effect of load line, in order to avoid cause patients to force. Otherwise the seal body or piston is easy to wear. 6, stroke larger oil cylinder, in central energy-saving injection molding machine servo cylinder and the piston rod should set support, in case of gravity downward bending phenomenon. 7, cylinder seals don't fit too tight, especially the u-shaped seal, if too tight, the energy-saving injection molding machine servo piston rod movement resistance will increase. All the above is to introduce the content, hope to be of help. If you want to learn more knowledge, you can visit our website, we will provide you with more professional information.
At a time when technology is essential for automatic injection moulding machine, ensuring that it works in a symbiotic way with your human employees is key.
FUHONG Injection Machine Co.,Ltd. assures you that you will be satisfied with its results and humbly request you to try this. We are hoping for a better business deal with you.
Based on the automatic injection moulding machine, here are the top compliance challenges businesses face, and what you can do to make them easier on ourselves.
Even automatic injection moulding machine are being made fine with advanced equipment.
Custom message
Chat Online
Chat Online
Chat Online inputting...
Sign in with: